Research & Partners

FLAKKOTING scientifically understood — with inspire AG in the Innosuisse project INNOFLAKK.

INNOFLAKK

From an experience-based process to a metamodel

Since 2023, PROFIN has been investigating the FLAKKOTING process together with inspire AG, the research partner affiliated with ETH Zurich, in the INNOFLAKK project funded by Innosuisse.

High-speed footage of the filament contact, process force measurement, 3D microscopy of the cutting edge before and after the process, simulation of the material removal — and from this a metamodel that predicts the process parameters from the workpiece and the target radius: MIKRO-KI.

The follow-up project on full automation with measurement in the cell is under way.

FLAKKOTING tool R3037 on a tungsten carbide drill, rendering
FLAKKOTING tool on the carbide drill — Rendering by AnalytikData.
Talks 2026

Presented in public

Arbeitskreis Hartmetall, 22/23 September 2026

«Mikroschneiden mit MIKRO-KI» (Micro cutting edges with MIKRO-KI) — Josef Vogel, PROFIN.

Schleifsymposium, 5/6 October 2026

«KI-gestützte Kantenpräparation durch FLAKKOTIEREN» (AI-supported edge preparation by FLAKKOTING) — Wegener, Vogel, Bosshard (inspire / PROFIN). Part 2 of the talk as a download.

Feasibility study

Your workpiece, our edge

Send us your workpiece. We prepare it in the laboratory, measure the edge in three dimensions and document radius, K-factor and process parameters — as the basis for your tool life comparison.

Request a feasibility study