ROBO-FLAKKO

The robot guides the workpiece to the tool: preparing edges and contours, removing primary and secondary burrs — in an enclosed cell with interchangeable tools and grippers matched to your component.

Modular FLAKKOTING cell

High-precision contour preparation

  • 1 to 3 units of type circular or planar FLAKKO, 200 – 1,500 rpm
  • 1 to 3 high-frequency spindles 8,000 – 25,000 rpm with pneumatic quick clamping for end brushes, tube brushes and special brushes
  • Brush trim measurement with Acoustic Emission System, tool control with RFID, automatic tool change from the magazine
  • Customer-specific robot gripper: engineering for your components, interchangeable grippers, individual fixtures
  • Indexing rotary table 1350 mm with pallets or linear transport up to 600 mm wide — part buffering for the night
  • Operation via touch panel, PROFIN software, remote maintenance
ROBO-FLAKKO cell, photo PROFIN
ROBO-FLAKKO cell with operating panel (photo PROFIN).
Technical data

The cell in figures

AssemblyValue
High-frequency spindles1 – 3, 8,000 – 25,000 rpm
Planar or circular FLAKKO1 – 3, 200 – 1,500 rpm
Indexing rotary table1350 mm, with pallets
Linear transport infeed/outfeed or continuous passWidth up to 600 mm, workpiece pallets from the customer
Planar / circular toolsØ 80 – 230 mm
End brushes, tube brushes and special brushes20 – 120 mm, Ø 3 – 10 mm
Examples

Workpieces the robot guides to the tool

Watch case, studio photo PROFIN

Watch case

Outer and inner contours on the case — without edge roll-off, with defined surface.

Threaded slide, studio photo PROFIN

Threaded slide

Inner and outer edges on the precision part with special tools in the high-frequency spindles.

Pallets with workpieces on the indexing rotary table of the ROBO-FLAKKO, photo PROFIN

Pallet out, pallet in

Presence check, part pick-up, processing, depositing — the cell runs, the operator swaps pallets.